Renesas User System Interface Board HS7047ECH61H Manual do Utilizador descarregar pdf (Página 137)

(1) [Condition] page

Figure 3.27 [Trace Acquisition Properties] Dialog Box ([Condition] Page)

[Sequential Trace Stop]: Use this option to set a sequential trace stop by using channels 1 to 7. The sequential

trace stop function allows trace acquisition to stop when the conditions of several

channels are satisfied in the specified order. Two to seven pass points and one reset

point are selectable as sequential trace stop conditions. The conditions are satisfied in

the order of 1 to 7. To use a sequential trace stop, select the checkbox of the channel.

To set a reset condition, select the [Reset Point] checkbox. Channel 8 is used for a

reset condition. When a reset condition is satisfied, all the sequential trace stop

conditions that have been satisfied will be cleared and the emulator starts checking

the first condition again. When a sequential trace stop is enabled, no setting is

available for the channels (out of 1 to 7) that are not used for the sequential trace stop

function.

[Run time count between trigger outputs]:

Selects channels for use in execution time measurement. Clicking [Use] allows

measurement of time in tracing. There are four types of channel combinations

consisted of those for the start and the end of measurement: 1-2, 3-4, 5-6, and 7-8.

[Free trace]: Selects the free trace mode. When [Free trace] is enabled, any trace acquisition

condition set will be ignored.

[Back]: Puts the setting back to the previous state at the time the dialog box has been

displayed.

1 2 ... 132 133 134 135 136 137 138 139 140 141 142 ... 242 243

Sem comentários

Renesas User System Interface Board HS7047ECH61H Manual do Utilizador Página 137