Renesas Emulator System E8 Especificações descarregar pdf (Página 40)

Renesas E8 Emulator

Introductory Guide for H8/300H Tiny

REJ06J0008-0100/Rev.1.00 March 2007 Page 38 of 43

8. Frequently Asked Questions

8.1 A communication error has occurred at startup.

If a communication error has occurred at startup, confirm the following.

1) The USB cable and user system interface cable are correctly connected.

2) The power is supplied to the CPU board when an external power source is used.

(Turn on the power after the [Power Supply] dialog box appears.)

3) The H8/3664 is selected for the target device.

8.2 A communication error has occurred during debugging.

The firmware may have gone out of control due to user program execution (going out of control or accessing to the

monitor area). Disconnect the USB cable of the E8 emulator from the host computer, connect it again, and then restart

the emulator software.

8.3 Do the on-chip peripheral modules work after a break occurs?

While the program is stopped due to a break, the CPU does not accept interrupts but the peripheral modules continue

operation. For example, when the user program stops due to a break after a timer has started counting, the timer

continues counting but the CPU does not accept timer interrupts.

8.4 Other Frequently Asked Questions

Refer to the FAQs at the following website address for the questions and answers about the Renesas products including

the E8 emulator.

http://www.renesas.com/e8 (Global site)

Access the above address and click the FAQs at the left side of the page.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 46 47 48

Sem comentários

Renesas Emulator System E8 Especificações Página 40