Renesas Emulator System E8 Guia do Utilizador descarregar pdf (Página 30)

CSE8E10-2

Using breakpoints

IAR C-SPY® Hardware Debugger Systems

User Guide

These commands are available on the emulator menu:

1 Not available for all targets

Restrictions for the Start/Stop Function

The Start/Stop function has the following restrictions:

● Do not set any breakpoints in the specified routine.

● Do not step into the specified routine.

● When a stack is used, make sure it is the user stack and not the interrupt stack.

● Disable interrupts during the execution of the specified routine.

Using breakpoints

This section provides an overview of the available breakpoints for the C-SPY hardware

debugger systems. The following is described:

● Available breakpoints, page 19

● Code breakpoints, page 20

● The Execution Address Breakpoint dialog box, page 20

● The Software breakpoint dialog box, page 21

● Log breakpoints, see the IAR Embedded Workbench® IDE User Guide.

● The Break Condition dialog box, page 22

● The Breakpoint Usage dialog box, page 23

● C-SPY use of breakpoints, page 24.

Menu command Description

Breakpoint Usage Displays the Breakpoint Usage dialog box, see the The Break-

point Usage dialog box, page 23.

Show Emulator Setting

Displays the Emulator Setting dialog box, see the Maintaining

the connection to the hardware, page 8.

Start/Stop Function Setting

Lets you execute specified routines of your application immedi-

ately before starting and immediately after halting the applica-

tion execution. The specified routines are executed when the

operations Go and Step are performed. A dialog box where

you can specify start and stop as labels or addresses is dis-

played. See also Restrictions for the Start/Stop Function, page 18.

Table 6: Commands on the E8a Emulator menu

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 40 41

Sem comentários

Renesas Emulator System E8 Guia do Utilizador Página 30