Renesas Emulator System SH7362 Manual do Utilizador descarregar pdf (Página 32)

E1/E20 Emulator Appendix A

R20UT0398EJ0400 Rev.4.00 Page 32 of 39

May 16, 2014

(2) Click on the [START] button to start the self-checking program.

If the user interface cable has not been connected to the self-checking connector, the following message is

displayed:

“Please connect the user interface cable to the self-check connector on E1 or E20 in a correct direction.”

Check that the user interface cable is connected to the self-checking connector in the right direction as shown in

Figure A.1, and click on the [OK] button. This starts the self-checking program.

Figure A.3 Checking the Connection

If the user interface cable has not been connected to the self-checking connector when the [OK] button is clicked

on, “FAIL” is displayed on the screen (see figure below). Correctly connect the cable to the self-checking

connector and click on the [START] button again to start the self-checking program.

Figure A.4 [FAIL] at the Start of Self-Checking

(without the Cable Connected to the Self-Checking Connector)

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 38 39

Sem comentários

Renesas Emulator System SH7362 Manual do Utilizador Página 32