Renesas M16C/30P Manual do Utilizador descarregar pdf (Página 22)

E8a Emulator Section 7 Debugger Setting

2. [Emulator mode] tab

Device selection, mode specification and power supply setting are made from the [Emulator mode] tab of the

[Emulator Setting] dialog box.

Figure 7.2 [Emulator mode] Tab

[MCU Group]

Select the name of the MCU group to be used from the [MCU Group] drop-down list.

[Device]

Select the type of MCU to be used from the [Device] drop-down list.

[Mode]

- Erase Flash and Connect

When starting the debugger, the E8a emulator erases the Flash memory data for the MCUs and simultaneously

writes the E8a emulator program.

- Keep Flash and Connect

When launching the debugger, the E8a emulator retains the Flash memory data for the MCUs. Note that the area

for the E8a emulator program and the vector area used by the E8a emulator will change.

- Program Flash

The E8a emulator starts as a simple programmer. When downloaded, the E8a writes only the user program (E8a

emulator program is not written). Therefore, the program cannot be debugged in this mode.

REJ10J1639-0500

Rev.5.00 Page 19 of 23

- Debugging of CPU rewrite mode

Select this setting when debugging the program which rewrites the CPU. In this mode, the following debug

operation which rewrites the Flash memory cannot be executed.

- Setting the PC break points

- Changing the memory contents in the Flash memory area

In this mode, when starting the debugger, the E8a emulator erases the Flash memory data for the MCUs and

simultaneously writes the E8a emulator program.

When [Execute the user program after ending the debugger.] is selected, with the E8a emulator connected to the

user system, the user program is executed at the same time the debugger is terminated. This check box setting is

available only when the [Program Flash] mode is selected.

Apr.30.10

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 28 29

Sem comentários

Renesas M16C/30P Manual do Utilizador Página 22