Renesas M3T-SRA74 Manual do Utilizador descarregar pdf (Página 43)

E8a Emulator User's Manual 3. Preparation before Use

(2) The pin assignments of the connector are shown in the section of ‘Pin Assignments of the

E8/E8a Connector’ in the additional documents for the E8a emulator user’s manual.

Pin 1

Pin 2

User system

Connector

User system interface cable

Figure 3.9 Connecting the User System Interface Cable to the User System

Notes: 1. To connect the signals output from the E8a connector, refer to the MCU pin

alignment.

2. To remove the user system interface cable from the user system, pull the connector

upward.

3. The range of frequencies that the emulator operates at is different according to the

MCUs used.

4. Connect the signals from the E8a connector as shown in section 3 or section 4 in

the additional documents for the E8a emulator user’s manual.

REJ10J1655-0400 Rev.4.00 Page 27 of 158

Apr 30, 2010

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 176 177

Sem comentários

Renesas M3T-SRA74 Manual do Utilizador Página 43