Renesas Technology, Tools FAQs
Last Updated: March 3, 2000
Document Number: 01050916_e
Q.
I am using PC4701 with M38000TL2-FPD. When I startup the emulator system, the emulator display immediately after startup is
not as indicated in the instructions. In normal operations, the target status RESET LED should go off, but it remains on. I assumed
that this indicates an error, but the emulator debugger still operated normally. Why?
A.
With the emulator debugger PD38 V.3.00 Release 1 or later, the RESET LED remains on under normal conditions.
The firmware in PD38 V.3.00 Release 1 and later has been modified so that the MCU goes to reset status immediately after startup.
Therefore, RESET LED and others will turn on at the time of normal startup, as described below.
POWER LED: ON during connection to target, OFF when disconnected
CLOCK LED: ON
RESET LED: ON
RUN LED: OFF
HALT LED: OFF
When PD38 is started up under normal conditions, the MCU is released from reset mode and the RESET LED is turned OFF.
Top of Page | Back to Previous Page
Terms of Use Privacy Policy
(C)2004 Renesas Technology Corp., All Rights Reserved.
Comentários a estes Manuais