Renesas FLASH Development Toolkit 3.07 Manual de Instruções descarregar pdf (Página 58)

Maintenance and Test Procedures

Access Control Design Guide

4. Select the communications settings to the database unit. If you are using serial communications, the

Baud rate must be the same as set at the database unit (normally 9600). Leave Other Options at

the default settings (as shown in the picture).

5. Click Search, then select the DCU radio button. The following shows an example of the information

displayed.

The tree on the left side of the screen lists each database unit and controller found. The tree has the

following features:

This represents the "node". That is, the database unit and its controllers. The

address of the database unit is shown here.

This represents the door controller section of a database unit such as a 4DBC.

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 72 73

Sem comentários

Renesas FLASH Development Toolkit 3.07 Manual de Instruções Página 58