Renesas M16C Manual do Utilizador descarregar pdf (Página 274)

11. Display the Cause of the Program Stoppage

If the program is stoped by the debug function, the cause of the stoppage is displayed in the Output

window or Status window ([Platform] sheet).

The contents of a display and the meaning of "the cause of the stoppage" are as follows.

Disp y

The cause of the stoppage

Halt The stop by the [Halt Program] button/menu

S/W break Software break

Address match interrupt break Address interrupt break

H/W event, Combination Hardware break, logical combination AND or AND(same

time)condition was met

H/W event, Combination, Ax Hardware break, logical combination OR condition was

met

(Ax: The event number of which condition was met.)

H/W event, State transition, from xx Hardware break, State Transition condition was met

(from xx: previous state (start, state1, state2))

H/W event, State transition, Timeout Hardware break, State Transition, Time Out condition was

met

H/W event, Access protect error Protect break

Note

To be able to show the cause of break or not depends on the connected target. Some targets may

always show "Halt" or show "---".

262

1 2 ... 269 270 271 272 273 274 275 276 277 278 279 ... 293 294

Sem comentários

Renesas M16C Manual do Utilizador Página 274