Renesas M3T-ICC740 Informações Técnicas descarregar pdf (Página 29)

Table

Table Table

Table 4

New Project Wizard Execution Steps

New Project Wizard Execution StepsNew Project Wizard Execution Steps

New Project Wizard Execution Steps

Step Selection

Step 1 For the target chip, select the “740 Family(ICC740)”. If the

M3T-SRA74 is installed in your computer, you will see the “740

Family” also displayed for the target chip, but be sure to select

the “740 Family(ICC740)”.

Step 2 Select a C Project.

Step Compiler For the compiler package, select the “TW74”. When this is

selected, the ICC740 will be used when you compile. For the

startup program, select the check box titled “A default startup

program is used”

Step Finish Click the Finish button.

At this point in time, the files in Table 5 are generated in the working directory.

Table

Table Table

Table 5

New Files Created in the Working Directory

New Files Created in the Working DirectoryNew Files Created in the Working Directory

New Files Created in the Working Directory

proj_1

.tmk Project file (makefile format)

proj_1

.tmi Project file (development member and document information)

startup.s31 Startup program

lnk740.xcl Link command file for XLINK

5.2. Complementing the Project

If the new project you are creating is an ICC740 project, you must complement it before you

can proceed.

The lnk740.xcl file copied to the working directory when creating a new project is the

command file for the linker XLINK. A method on how to locate segments and related other

information are written in it. This file is not registered to the project yet. Therefore, register

it following the procedure described below.

1. In the project tree of the project editor, click the plus sign [+] for all to

display .\proj_1.695.

2. Click [+] for .\proj_1.695 following all to display .\proj_1.cmd.

3. Click .\proj_1.cmd and then the Add File button (

Figure 20 (a)).

4. In the ensuing Open dialog box, select “All files” for File Types and add the lnk740.xcl file

present in the working directory (

Figure 20 (b)).

5. When you add the lnk740.xcl file, the screen changes to the one shown in

Figure 20 (c),

with lnk740.xcl registered to the project.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 52 53

Comentários a estes Manuais

Sem comentários

Renesas M3T-ICC740 Informações Técnicas Página 29

Comentários a estes Manuais

Manuais e produtos relacionados com Software Renesas M3T-ICC740