Renesas H8S/2628 Informações Técnicas descarregar pdf (Página 3)

1 / 6

HS2628EPI61HE-P(D)

Precautions on Using the H8S/2628 E6000 Emulator

Thank you for purchasing the H8S/2628 E6000 emulator.

Please note the followings when using this version of the H8S/2628 E6000 emulator.

1 Precautions on Using the Emulator

1.1 Memory Mapping

Cannot map both emulator memory and user memory in the address area block below at the same time. If

mapped, the previous mapped area changes to guarded area.

Block name Address area Block

name

Address area

SB0 H’000000-H’01FFFF LB0 H’100000-H’1FFFFF

SB1 H’020000-H’03FFFF LB1 H’200000-H’3FFFFF

SB2 H’040000-H’05FFFF LB2 H’400000-H’5FFFFF

SB3 H’060000-H’07FFFF LB3 H’600000-H’7FFFFF

SB4 H’080000-H’09FFFF LB4 H’800000-H’9FFFFF

SB5 H’0A0000-H’0BFFFF LB5 H’A00000-H’BFFFFF

SB6 H’0C0000-H’0DFFFF LB6 H’C00000-H’DFFFFF

SB7 H’0E0000-H’0FFFFF LB7 H’E00000-H’FFFFFF

1.2 I/O Register

HCAN registers are registered as "MC0_1_4" long size. It means MC0(1)-(4).

1.3 Voltage Follower Circuit

When setting the Vccdown detection voltage in the voltage follower circuit, make the setting be at least

3V on higher.

1.4 Event

1.4.1 Combination of Address-Range and Data Compare-Byte

When an address range is set as the address condition and byte data as the data condition, a break will

occur only at even addresses in the address range. When an address range is set as the address condition,

do not set an odd address as the Address Lo condition. Otherwise, a break will not occur even when the

conditions are satisfied.

1.4.2 Removing PC Breakpoints during Execution of the User Program

Do not remove PC breakpoints in the source window, [Disassembly] window, or [Label] window during

execution of the user program.

1.4.3 Recovery of PC Breakpoints by the Session File

Information on PC breakpoints that was saved in the session file is not available until a load module is

loaded. If necessary, load a load module or set new PC breakpoints.

1.5 Display of the Memory Content and Operation of Memory

1.5.1 Operating Memory during Execution of the User Program

The memory copy, memory compare, memory fill, and memory test functions are not available during

execution of the user program. These command lines are not available either.

1 2 3 4 5 6 7 8

Sem comentários

Renesas H8S/2628 Informações Técnicas Página 3