Renesas H8S/2378F Informações Técnicas descarregar pdf (Página 36)

Note: When installing the PCI card emulator, note the following:

1. Turn off the host computer.

2. Insert the emulator into the PCI slot in parallel.

3. Screw in the emulator after confirming the connector and cable positions.

2.4 Connecting the Card Emulator with the User System

(1) The connector must be installed to the user system. Table 2.1 shows the recommended

connector for the emulator.

Table 2.1 Recommended Connector

Type Number Manufacturer Specifications

2514-6002 3M Limited 14-pin straight type

Note: When the connector is used, do not install any components within 3 mm of the

connector.

(2) The pin arrangement of the connector is shown in section 6.2, Pin Arrangement of the Hitachi-

UDI Port Connector.

(3) Figure 2.4 shows how to connect the user system interface cable to the user system. Connect

the ground line of the cable to the user system ground. The end of the ground line has a hole

having a diameter of 3 mm, and therefore, when the ground line is screwed to the user system,

the screw diameter must be 3 mm.

Figure 2.4 Connecting the User System Interface Cable to the User System

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 169 170

Sem comentários

Renesas H8S/2378F Informações Técnicas Página 36