Renesas H8S/2338 Series Manual do Utilizador descarregar pdf (Página 10)

Simulator for H8/300, H8/300H and H8S 10 Specific SYStem Commands

SYStem.MemAccess Real-time memory access (non-intrusive)

Default: Denied.

SYStem.Mode Establish the communication with the simulator

Default: Down. Selects the target operating mode.

If the mode “Go” is selected, this mode will be entered, but the control button in the SYStem window jumps

to the mode “Up”.

Format: SYStem.MemAccess CPU | Denied<cpu-specific>

SYStem.Access (deprecated)

CPU Real-time memory access during program execution to target is enabled.

Denied Real-time memory access during program execution to target is disabled.

Format: SYStem.Mode <mode>

<mode>: Down

NoDebug

Down The CPU is in reset. Debug mode is not active. Default state and state after fatal

errors.

NoDebug The CPU is running. Debug mode is not active. Debug port is tristate. In this

mode the target should behave as if the debugger is not connected.

Go The CPU is running. Debug mode is active. After this command the CPU can be

stopped with the break command or if any break condition occurs.

Up The CPU is not in reset but halted. Debug mode is active. In this mode the CPU

can be started and stopped. This is the most typical way to activate debugging.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 21 22

Sem comentários

Renesas H8S/2338 Series Manual do Utilizador Página 10