Renesas M34502T-MCU Informações Técnicas descarregar pdf (Página 21)

( 19 / 38 )

4.6 Connecting to the Target System

(1) For 4502 and 4507 Groups

How to connect the M34502T-MCU to the target system when using for 4502 and 4507 Groups

is shown below.

Make note of the fact that it is not possible to connect the M34502T-MCU directly to the foot

pattern of the MCU package (24P2Q-A).

a. Connecting to 2.54-mm-pitch Dual-in-line Pins on the Target System

Use the 26-wire normal-pitch cable (included) to connect the 26-pin dual-in-line pins on the

target system. The following products are required for connection to the target system.

• 60-wire half-pitch cable (40 cm)

• Pitch converter board PCA4029

• 26-wire normal-pitch cable (10 cm)

Figure 4.8 shows the M34502T-MCU board connected to the target system using the 26-wire

normal-pitch cable. Table 4.8 lists the connector signal assignments of the 26-wire normal-pitch

cable. And Figure 4.9 shows the pin layout of the 26-wire normal-pitch cable.

Figure 4.8 Connection to the target system using dual-in-line pins

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 39 40

Sem comentários

Renesas M34502T-MCU Informações Técnicas Página 21