Renesas H8S/2378F Informações Técnicas descarregar pdf (Página 21)

4.2.6 Adapter Board Pin Settings

Set the pins on the adapter board (FDM) for the boot mode.

For example, set the output of FWx pin to high (1) (open jumper J15) and that of MD2 (IO0) to low (0).

In this example, the FWx pin outputs 1 for setting a mode and MD2 (IO0) outputs 0 for serial communication

connection.

Turn off the power and select the boot mode (mode 3) using DIP switch 6. Set DIP switch 6 as follows. When you have

set the pins, turn on the power.

Table 4-3 Operating Mode Settings

Jumper FWE MD2 MD1 MD0 SCI Switch MCU

Operating

Mode

CPU Operating

Mode

J15 FWx (Pin 3) on

the Adapter

Board

SW6-3 SW6-2 SW6-1 MD2 (Pin 9) on

the Adapter

Board

3 Boot mode 1 (Open) 1 (Output 1) 0 (ON) 1 (OFF) 1 (OFF) 0 (Output 0)

When you have set the pins, click "OK."

When the device has been connected, click "OK."

Note: Do not operate the mode switches during CPU operation. Be sure to operate the FWE and MD pins after turning

off the power to the board or while pressing the RESET button.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 108 109

Sem comentários

Renesas H8S/2378F Informações Técnicas Página 21