Renesas H8S/2378F Informações Técnicas descarregar pdf (Página 75)

Set the pins on the adapter board (FDM) for the user boot mode.

For example, set the output of FWx to high (1) and that of MD2 to low (0).

In this example, the FWx pin outputs 1 for selecting a mode (jumper J15 is open) and MD2 (IO0) outputs 0 for serial

communication connection.

Turn off the power and select an expanded mode with on-chip ROM enabled (mode 4) or single-chip mode (mode 7).

To select the mode, use DIP switch 6. When you have set the pins, turn on the power.

Table 4-7 Operating Mode Settings

Jumper FWE MD2 MD1 MD0 SCI Switch MCU

Operating

Mode

CPU Operating

Mode

J15 FWx (Pin 3) on

the Adapter

Board

SW6-3 SW6-2 SW6-1 MD2 (Pin 9) on

the Adapter

Board

4 Expanded mode with

on-chip ROM

enabled

1 (Open) 1 (Output 1) 1 (OFF) 0 (ON) 0 (ON) 0 (Output 0)

7 Single-chip mode 1 (Open) 1 (Output 1) 1 (OFF) 1 (OFF) 1 (OFF) 0 (Output 0)

When you have set the items, click "Finish."

Note: Do not operate the mode switch during CPU operation. Be sure to operate the FWE and MD pins after turning the

power to the board off or while pressing the RESET button.

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 108 109

Sem comentários

Renesas H8S/2378F Informações Técnicas Página 75