Renesas H8S/2628 Informações Técnicas descarregar pdf (Página 424)

100

101

396

H.2 Diagnostic Test Procedure Using Test Program

Insert the CD-R (HS2628EPI61SR supplied with the emulator) into the CD-ROM drive of the host computer,

move the current directory to <Drive>:\Diag with a command prompt, and enter one of the following commands

according to the PC interface board used to initiate the test program:

1. PCI bus interface board (HS6000EIC01H or HS6000EIC02H)

> TM2628 –PCI (RET)

2. PCMCIA interface card (HS6000EIP01H)

> TM2628 –PCCD (RET)

3. LAN adapter (HS6000ELN01H)

> TM2628

–

ELN (RET)

4. USB adapter (HS6000EIU01H)

> TM2628

–

USB (RET)

The HEW must be installed before the test program is executed.

Be sure to initiate the test program from <Drive>:\Diag. Do not initiate it from a directory other than

<Drive>:\Diag, such as > <Drive>:\Diag\TM2628 –PCI (RET). If the test program is initiated when the current

directory is not <Drive>:\Diag, the test program will not operate correctly.

When –S is added to the command line such as >TM2628 –PCI –S (RET), steps 1 to 19 will be repeatedly

executed. To stop the execution, enter Q.

Notes: 1. <Drive> is a drive name for the CD-ROM drive.

2. Do not remove the CD-R from the CD-ROM drive during test program execution.

1 2 ... 419 420 421 422 423 424 425 426 427 428 429 430

Comentários a estes Manuais

Sem comentários

Renesas H8S/2628 Informações Técnicas Página 424

Comentários a estes Manuais

Manuais e produtos relacionados com Software Renesas H8S/2628