Renesas SuperH SH7343 Informações Técnicas descarregar pdf (Página 105)

Target interface (SH7300(SH-MobileV)) Jun. 30, 2009 (First Edition)

MDR connector

Signals

CPU Pin No. CPU Pin No.Pin

No.

Signal

Input/

Output

CSP-256

No.

Signal

Input/

Output

CSP-256

1 AUDCK Output L20 2 GND

3 AUDATA0 Output L18 4 GND

5 AUDATA1 Output M20 6 GND

7 AUDATA2 Output N17 8 GND

9 AUDATA3 Output M21 10 GND

11 AUDSYNC Output P17 12 GND

13 N.C. 14 GND

15 N.C. 16 GND

17 TCK Input K20 18 GND

19 TMS Input J21 20 GND

21 TRST Input J17 22 GND(ASEMD0)

(Input) (K21)

23 TDI Input K17 24 GND

25 TDO Output J18 26 GND

27 ASEBRKAK Output N20 28 GND

29 VCC

*3 *4

Output 30 GND

31 RESETP Output H17 32 GND

33 GND 34 GND

35 N.C. 36 GND

・ For the pin where stated as N.C. in the table, leave the signal unconnected.

*1: Input/output is based on the target system.

*2: To debug,

ASEMD0 pin needs to be brought to Low state.

Shown in the target connection reference diagram is the circuit that brings ASEMD0 pin to Low state when you connect ASEMD0 signal to the connector for

debugger.

If you do not connect ASEMD0 signal to Pin No. 22 of the connector for debugger, the circuit that sets ASEMD0 pin by switch circuit will do. However, in such

case, do not connect ASEMD0 pin to Pin No. 22 of the connector for debugger, but connect Pin No. 22 of connector for the debugger to GND.

*3: In the target connection reference diagram, Pin No. 29 is VCC, however, CA pin can also be connected to Pin No. 29.

*4: For VCC, connect I/O power of CPU. Debugging can be performed even if the signal is N.C., however, by connecting I/O power, leak during

the target system power OFF can be prevented.

Target connection reference diagram

MDR connector specifications

Recommended connector

Manufacturer 3M

Model 10236-52A2JL

(Top view on the target board)

(Side view on the target board)

(Pin Configuration)

(For detailed dimensions of the connector,

refer to the documentation by manufacturer of the connector.)

*Please look at the pin configuration diagram above and make

sure that the connector is in the right direction before connecting.

Please check the pin number in the signal table above and make sure

the signal and the pin numbers match.

*1:

RESETP, which is connected to Pin No. 31 of the connector for debugger, is the signal that debugger uses for monitoring the state of RESETP

pin of CPU.

1 2 ... 100 101 102 103 104 105 106 107 108 109 110 ... 203 204

Comentários a estes Manuais

Sem comentários

Renesas SuperH SH7343 Informações Técnicas Página 105

Comentários a estes Manuais

Manuais e produtos relacionados com Redes Renesas SuperH SH7343