
12
WARNING
When inserting the PCI-card emulator, note the following.
Failure to do so will damage the host computer.
1. Turn off the host computer.
2. Insert the emulator into the PCI slot in parallel.
3. Screw in the emulator after checking the connector and
cable positions.
2.4 Connecting the Card Emulator to the User System
(1) The H-UDI port connector must be installed to the user system. Table 2.1 shows the
recommended H-UDI port connector for the emulator.
Table 2.1 Recommended H-UDI Port Connector
Connector Type Number Manufacturer Specifications
14-pin connector 2514-6002 Minnesota Mining &
Manufacturing Ltd.
14-pin straight type
36-pin connector DX10M-36S Hirose Electric Co., Ltd. Screw type
DX10M-36SE,
DX10GM-36SE
Lock-pin type
Note: When the 14-pin connector is used, do not install any components within 3 mm of the
H-UDI port connector.
When the 36-pin connector is used, do not connect other signal lines to the H-UDI
port connector.
(2) Note that the TDO signal of the user system interface cable connector must be connected to
the TDI pin of the H-UDI port connector and the TDI signal of the user system interface cable
connector must be connected to the TDO pin of the H-UDI port connector. Section 6.2 shows
the pin arrangement of the H-UDI port connector.
(3) Figure 2.4 shows how to connect the user system interface cable to the user system when the
14-pin straight type connector is used. Connect the ground line of the cable to the user system
ground. The end of the ground line has a hole having a diameter of 3 mm, and therefore,
when the ground line is screwed to the user system, the screw diameter must be 3 mm.
Comentários a estes Manuais