Renesas User System Interface Board HS7047ECH61H Manual do Utilizador descarregar pdf (Página 132)

[External]: Selects an external area where no emulation memory is allocated as

the condition.

[Emulator]: Selects an external area where emulation memory is allocated as the

condition.

[Read/Write]: Sets read/write conditions. When [Don’t Care] has been selected, no

read/write condition can be set.

[Probe]: Sets the levels (high or low) of the external probe signals (PRB1 to PRB4) as the condition.

When [Don’t Care] has been selected, the level of the selected probe signal cannot be set as the

condition.

[Interrupt]: Sets the levels (high or low) of the IRQ and NMI signals as the condition. When [Don’t Care]

has been selected, the level of the IRQ or NMI signal cannot be set as the condition.

[Count]: Sets a satisfaction count condition. When [Don’t Care] has been selected, the satisfaction count

is defined as 1.

3.7.4 Editing Event Points

Handlings for settings other than software breakpoints, on-chip breakpoints, and on-emulator breakpoints are

common.

3.7.5 Modifying Event Points

Select an event point to be modified, and choose [Edit...] from the popup menu to open the dialog box that

corresponds the event, which allows the user to modify the event conditions. The [Edit...] menu is only available

when one event point is selected.

3.7.6 Enabling an Event Point

Select an event point and choose [Enable] from the popup menu to enable the selected event point.

3.7.7 Disabling an Event Point

Select an event point and choose [Disable] from the popup menu to disable the selected event point. When an

event point is disabled, the event point will remain in the list, but an event will not occur when the specified

conditions have been satisfied.

3.7.8 Deleting an Event Point

Select an event point and choose [Delete] from the popup menu to remove the selected event point. To retain the

event point but not have it cause an event when its conditions are met, use the [Disable] option (see section

3.15.7, Disabling an Event Point).

1 2 ... 127 128 129 130 131 132 133 134 135 136 137 ... 242 243

Sem comentários

Renesas User System Interface Board HS7047ECH61H Manual do Utilizador Página 132