Renesas User System Interface Board HS7047ECH61H Manual do Utilizador descarregar pdf (Página 30)

2.2 Emulator Connection

2.2.1 Connecting the User System

WARNING

Always switch OFF the emulator and user system before

connecting or disconnecting any CABLES. Failure to do so will result

in a FIRE HAZARD and will damage the user system and the emulator

or will result in PERSONAL INJURY. The USER PROGRAM will be

LOST.

1. Check that the emulator power switch is turned off. Ensure that the power lamp on the right side of the

E6000H station's front panel is not lit.

2. Remove the AC power cable of the E6000H station from the outlet (if the cable is connected to the outlet).

3. Connect pin 1 on the user system connector to the connector installed at the bottom of the E6000H user

system interface board. When connecting the connector, prevent the upper or lower side of the board from

lifting off the connector. Alternately tighten the screws on both sides of the board.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 242 243

Sem comentários

Renesas User System Interface Board HS7047ECH61H Manual do Utilizador Página 30