Renesas R8C/Tiny Series Manual descarregar pdf (Página 172)

R8C/10 Group 19. Usage Notes

Rev.1.20 Jan 27, 2006 page 162 of 180

REJ09B0019-0120

19. Usage Notes

19.1 Stop Mode and Wait Mode

19.1.1 Stop Mode

When entering stop mode, set the CM10 bit to “1” (stop mode) after setting the FMR01 bit to “0” (CPU

rewrite mode disabled). The instruction queue pre-reads 4 bytes from the instruction which sets the

CM10 bit in the CM1 register to “1” (stop mode) and the program stops. Insert at least 4 NOP instruc-

tions after inserting the JMP.B instruction immediately after the instruction which sets the CM10 bit to

“1”.

Use the next program to enter stop mode.

• Program of entering stop mode

BCLR 1, FMR0 ; CPU rewrite mode disabled

BSET 0, PRCR ; Protect exited

BSET 0, CM1 ; Stop mode

JMP.B LABEL_001

LABEL_001:

NOP

19.1.2 Wait Mode

When entering wait mode, execute the WAIT instruction after setting the FMR01 bit to “0” (CPU re-

write mode disabled). The instruction queue pre-reads 4 bytes from the WAIT instruction and the

program stops. Insert at least 4 NOP instructions after the WAIT instruction.

Also, the value in the specific internal RAM area may be rewritten when exiting wait mode if writing to

the interna RAM area before executing the WAIT instruction and entering wait mode. The area for a

maximum of 3 bytes is rewirtten from the following address of the internal RAM in which the writing is

performed before the WAIT instruction. If this causes a problem, avoid by inserting the JMP.B instruc-

tion between the writing instruction to the internal RAM area and WAIT instruction as shown in the

following program example.

• Example to execute WAIT instruction

Program Example MOV.B #055h,0601h ; Write to internal RAM area

•••

JMP.B LABEL_001

LABEL_001 :

FSET I ; Interrupt enabled

BCLR 1,FMR0 ; CPU rewrite mode disabled

WAIT ; Wait mode

NOP

When accessing any area other than the internal RAM area between the writing instruction to the

internal RAM area and execution of the WAIT instruction, this situation will not occur.

1 2 ... 167 168 169 170 171 172 173 174 175 176 177 ... 198 199

Sem comentários

Renesas R8C/Tiny Series Manual Página 172